Samsung DW5500 Handbuch Seite 13

NOTE
How water softener regeneration works (ECO cycle with H3 level setting)
• Operates for about 2 minutes when drying starts and uses 2 L water, 0.0002 kWh
energy
• Regenerates once every 5 cycles
How to set the softener level
The dishwasher is designed to allow for adjusting the amount of salt consumed based on
the hardness of the water used. This is intended to optimise and customise the level of salt
consumption so that the salt consumption could be set proceed as follows:
The buttons used to enter the setting mode may vary depending on the model.
Check the buttons for your model.
• DW6*R70**** / DW5*R407*BB / DW5*R406*BB : A (AUTO)
• DW5*R405*BB / DW5*R404*BB : A (Normal)
1. Press and hold the A button for five seconds.
2. Press the Delay Start button to select the water hardness level setting menu.
- The display shows the current setting.
3. Press the A button to change the setting.
- You can select from H1-H6 (soft - hard)
4. Wait 5 seconds to save the setting.
• DW6*M6***BB / DW60M6070IB : A (Pre Wash)
• DW6*M5***BB / DW60M5070IB : A (Express)
• DW6*M****F*/S*/U* models : A (Program)
1. Press the A button for five seconds to select the water hardness level setting menu.
- The display shows the current setting.
2. Press the A button to change the setting.
- You can select from H1-H6 (soft - hard)
3. Wait 5 seconds to save the setting.
WEB_Dishwaser_Global_00_EN.indd 13
English 13
2021-04-09 12:01:12