Hama Add-On Bedienungsanleitung Seite 5

4. Getting started
4.1 Inserting / changing the batteries
Warning - Batteries
• When inserting batteries, note the correct polarity
(+ and - markings) and insert the batteries
accordingly. Failure to do so could result in the
batteries leaking or exploding.
• Only use batteries (or rechargeable batteries) that
match the specified type.
• Before you insert the batteries, clean the battery
contacts and the polar contacts.
• Do not allow children to change batteries without
supervision.
• Do not mix old and new batteries, or batteries of
different types or from different manufacturers.
• Remove the batteries from products that are not
being used for an extended period (unless these
are being kept ready for an emergency).
1
4
• Press the battery symbol on the housing and pull the housing cover upwards over the control dial.
• Remove the spent batteries and dispose of them if required. Insert two new batteries of type AA. Take care to
ensure the correct polarity as shown in the diagram in the battery compartment.
• "LA" flashes on the display.
• Close the battery compartment by pushing the housing cover back onto the control dial.
• Wait for around 30 seconds until the "LA" display lights up solid. The thermostat can now be fitted to the
radiator.
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not burn batteries.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or allow
them to enter the environment. They can contain
toxic, environmentally harmful heavy metals.
• Remove spent batteries from the product and
dispose of them without delay.
• Avoid storing, charging and using in extreme
temperatures and at extremely low atmospheric
pressures (such as at high altitudes).
2
5
Flashing
3
30 sec.