Power Cord; Connection Diagram - Pelgrim IK1164 Ausführliche Gebrauchsanleitung

CONNECTION

POWER CORD

(appliance without a power cord)
• The following may be used for connection:
• PVC insulated connection cables type H05 VV-F or H05V2V2-F with yellow-and-green
protective conductor, or other equivalent or superior cables.
• Exterior cable diameter should be at least 8.00 mm.
• Run the power cord through a cord strain relief (clamp) which protects the cable from
being pulled out.
220-240V ~ / 50/60Hz 220-240V ~ / 50/60Hz
4
N2
3
L2
N1
2
5
L1
PE PE
1
380-415V 2N ~ / 50/60Hz 380-415V 2N ~ / 50/60Hz
4
N2
3
L2 L2
N1
2
5
L1
PE PE
1
30
803412_en.indd 30 803412_en.indd 30

CONNECTION DIAGRAM

Single phase connection (32 A)
• Single-phase connection (1 1N, 220–240 V~ /50/60 Hz):
 Voltage between line and neutral conductor is 220–240 V~.
Install a jumper between terminals L1 and L2, and between
terminals N1 and N2.
 The circuit should be fi tted with a fuse of at least 32 A. Power
cord core cross-sectional area should be at least 4 mm
Two phase connection (16A)
• 2 phases, 1 neutral conductor (2 1N, 380–415 V~ /50/60 Hz):
 Voltage between the line and neutral conductor is 220–
240 V~.; voltage between lines is 380–415 V~. Install a jumper
between the terminals N1 and N2. The circuit should be fi tted
with at least two fuses of at least 16 A each. Power cord core
cross-sectional area should be at least 1.5 mm
1. Check the voltage. Before connecting
the appliance, make sure the voltage
specifi ed on the rating plate conforms to
the voltage of your power mains.
The voltage of your power mains
(220–240 V between L and N) should
be checked by an expert using an
appropriate measuring device.
2. Open the cover of the connection
terminal box.
3. Connect the wires according to your type
of appliance.
The jumpers are provided on the
connection terminal.
2 .
2
.
18. 06. 2020 06:57:06 18. 06. 2020 06:57:06