Hand programming of the device
LCD screen after switch on:
Start up...
1. Shows the modulation of the output signal
2. Output frequency
3. Data rate of the output signal
4. Not relevant
Over view main menu:
The main menu occurs after pushing the button "Menu".
Menu navigation by using arrow buttons.
Setting confirmation by "Enter".
One step back through pushing button "Back"
1 Status
2 Input sets
Alarm Status
1.
If there is no signal at the input, the menu point "Alarm Status" will be shown: "No video in"
and the alarm indicator (9) turns on. This lights also red if a bit rate overflow occurs at the
output.
Press Enter to enter "Status" and it displays the working time duration of the device. It times
upon power on.
All manuals and user guides at all-guides.com
Start ok...
3 Modulator
4 TS config
1
DVB-T
750.00MHz
0.000 Mbps
0.0M
3
5 Network
6 System
2
4
25