Specifications - Pioneer PRS-A900 Bedienungsanleitung

Specifications

Power source ........................................................................................................ 14.4 V DC (10.8 V to 15.1 V allowable)
Grounding system .......................................................................................................................................... Negative type
Current consumption ........................................................................................................ 28 A (at continuous power, 4 Ω)
Average current drawn* .......................................................................................................... 9 A (4 Ω for four channels)
Fuse ........................................................................................................................................................................ 25 A × 2
Dimensions ........................................................................................................ 282 mm (W) × 65 mm (H) × 371 mm (D)
Weight .................................................................................................................... 6.4 kg (Leads for wiring not included)
Maximum power output .............................................................................................. 100 W × 4 (4 Ω) / 200 W × 2 (4 Ω)
Continuous power output .......................................................... 50 W × 4 (at 14.4 V, 4 Ω, 20 Hz to 20 kHz 0.08% THD)
Load impedance ........................................................................................................................ 4 Ω (2 Ω to 8 Ω allowable)
Frequency response ........................................................................................................ 10 Hz to 100 kHz (+0 dB, –1 dB)
Signal-to-noise ratio .................................................................................................................... 108 dB (IEC-A network)
Distortion ........................................................................................................................................ 0.003 % (10 W, 1 kHz)
Separation .................................................................................................................................. 75 dB (100 Hz to 10 kHz)
Slew rate.............................................................................................................................................................. 70 V/µ sec.
Damping factor .............................................................................................................................................................. 100
Gain control .............................................................................................................................................. 400 mV to 6.5 V
Maximum input level / impedance ...................................................................................................... RCA: 6.5 V / 22 kΩ
Note:
• Specifications and the design are subject to possible modification without notice
due to improvements.
*Average current drawn
• The average current drawn is nearly the maximum current drawn by this unit
when an audio signal is input. Use this value when working out total current
drawn by multiple power amplifiers.
100 W × 2 (at 14.4 V, 4 Ω, 20 Hz to 20 kHz 0.8% THD)
50 W × 4 (at 14.4 V, 2 Ω, 20 Hz to 20 kHz 0.8% THD)
(Bridge connection: 4 Ω to 8 Ω allowable)
12 A (4 Ω for two channels)
14