Specifications - Pioneer GM-5200T Bedienungsanleitung

Specifications

Power source .......................................................................................................... 14.4 V DC (10.8 — 15.1 V allowable)
Grounding system .......................................................................................................................................... Negative type
Current consumption .................................................................................................... 30.0 A (at continuous power, 4 Ω)
Average current drawn* ...................................................................................................... 10.0 A (4 Ω for two channels)
Fuse ........................................................................................................................................................................ 30 A × 2
Dimensions ...................................................................................................................... 300 (W) × 61 (H) × 336 (D) mm
Weight .................................................................................................................... 3.9 kg (Leads for wiring not included)
Maximum power output .............................................................................................. 250 W × 2 (4 Ω) / 760 W × 1 (4 Ω)
Continuous power output ........................................................ 125 W × 2 (at 14.4 V, 4 Ω, 20 Hz — 20 kHz 0.2% THD)
Continuous power output (DIN power) ............................ 175 W × 2 (4 Ω) / 520 W × 1 (4 Ω) (DIN45324, +B=14.4 V)
Load impedance .......................................................................................................................... 4 Ω (2 — 8 Ω allowable)
Frequency response ........................................................................................................ 10 Hz — 50 kHz (+0 dB, –1 dB)
Signal-to-noise ratio ...................................................................................................................... 95 dB (IEC-A network)
Distortion ........................................................................................................................................ 0.015 % (10 W, 1 kHz)
Separation ...................................................................................................................................................... 70 dB (1 kHz)
Low pass filter .............................................................................................................................. Cut off frequency: 80 Hz
Bass Boost .............................................................................................................................................. Frequency: 50 Hz
Gain control .................................................................................................................................. RCA: 200 mV — 6.5 V
Maximum input level / impedance ...................................................................................................... RCA: 6.5 V / 22 kΩ
Note:
• Specifications and the design are subject to possible modification without notice
due to improvements.
*Average current drawn
• The average current drawn is nearly the maximum current drawn by this unit
when an audio signal is input. Use this value when working out total current
drawn by multiple power amplifiers.
11
380 W × 1 (at 14.4 V, 4 Ω, 20 Hz — 20 kHz 0.8% THD)
190 W × 2 (at 14.4 V, 2 Ω, 20 Hz — 20 kHz 0.8% THD)
(Bridge connection: 4 — 8 Ω allowable)
19.0 A (4 Ω for one channel)
Cut off slope: –12 dB/oct
Level: 0/6/12 dB
Speaker: 0.8 — 26 V
Speaker: 26 V / 40 kΩ