Function; Storing Food - Gastrodomus SALADETTE Bedienungsanleitung

Function

Storing food

To get the best results from your appliance, follow these instructions:
Only store foodstuffs in the appliance when it has reached the correct operating temperature.
l
Ensure GN container bays are full at all times, even if the GN containers are unused or empty.
l
Empty bays will greatly reduce efficiency of the appliance.
Always close the door,lid or drawer when not in use.
l
Do not place uncovered hot food or liquid inside the appliance.
l
Wrap or cover food where possible.
l
Do not obstruct the fans inside the appliance.
l
Avoid opening the doors/drawers for prolonged periods of time.
l
The maximum load for a shelf/drawer is 30 kg.
l
The food must be put into container before placed into cabinet or on the shelf. Food must not
l
be placed into food cabinet directly.
l When wet food/vegetable is put in the Saladette, it's normal that ice (snow) appears on the
surface.
Turn on
Close the door/lid/drawer of the appliance.
l
Ensure the power switch is set to [ O ] and turn on at the socket.
l
Switch on the Power [ I ]. The current temperature within the appliance is displayed.
l
The on the control panel will flash for 3-min to indicate a delay between the motor
l
compressor being stopped and then restarted.
Open/close the lid or drawer
WARNING: The sliding lid does not have a locking mechanism. Always make sure that the lid is in
the 'half-open' position before opening.
WARNING: Do not pull the drawer out of its full open position to avoid any hurt.
The lid of the GSA is multi-positional:
With the lid closed, slide the panel back into the half open position. This allows partial access to
l
the GN container trays.
Lift the lid up and back so the hinge settles into the support slot.
l
Lift the lid up and completely back so the GN container trays are completely exposed.
l
GB
7 P2M006STD - Ver.1.4