Herth+Buss ELPARTS 95950005 Bedienhinweis Seite 9

Operating Instruction
To clean the battery charger, use a dry
cloth. Always disconnect the battery char-
EN
ger from the power supply mains. Never
use damp or wet cloths.
Battery charger safety
Periodically check the battery charger,
the power supply cable and the clamps.
Do not use the battery charger when
damaged, to avoid the risk of electric
shocks; do not try to open or modify it.
Connect the battery charger to the mains
socket, making sure that the mains voltage
matches that stated on the power supply
device. (See TECHNICAL DATA table)
Do not cover the battery charger when
using it. Allow adequate space for ven-
tilation.
Do not use the battery charger in humid
or wet environments; do not expose it to
rain. Wet and contaminated environments
increase the risk of electric shocks.
www.herthundbuss.com
95950005
Personal protective equipment
to wear while operating battery
charger
WARNING
Failure to observe the following war-
nings may result in physical injury and/
or disease.
Always wear safety shoes
Always wear eye protection
Always wear protective gloves
against physical agents while
operating battery charger
Operating Instruction
WARNUNG
Additional personal protective equipment to wear according to the values found
in the environmental hygiene/risk analysis survey if the values exceed the limits
under current regulations.
Tachnical data
Description
For use with batteries
Rated voltage
Charging voltage
Absorbed power
Battery charging
capacity
Battery holding
capacity
Clamp cable length
Clip cable section
Degree of protection
Power supply cable
length
Dimensions
Weight
Signalling LEDs
The front panel of the battery charger
accommodates 15 LEDs, including 4 battery
status LEDs, indicating the following:
"Full": battery is charged, and is in
charge maintenance status
16 17
"Charging": battery is charging
"Fault": battery is damaged
Value
"Reverse": polarity reversal
1 battery charge status LED, "led ON"
12 V Wet - Agm - Lithi-
um LiFePO4 (blue colour)
1 operating status LED, "Start/Stop"
110 V - 240 V 50/60 Hz
(yellow colour); indicates whether output
12 V max
is in accordance with selected mode
2 operating mode LEDs, "Function":
1800 Watt
Flash or Charge (yellow LED)
10+1200 Ah
4 supplied current LEDs, "Amperage" ,
described below (yellow LED)
10+3000 Ah
3 supply voltage and battery type LEDs,
"Volt/Batt" , described below (yellow LED).
2.7 m
25 mm2
The front panel of the battery charger
accommodates 5 buttons:
IP20
"Start/Stop": starts or stops supply in
1.7 m selected mode
"Function": selects operating mode
350 x 450 x 150 mm
"Volt/Batt": selects supply voltage or
8.8 kg type of battery to charge
"Amperage": selects supplied current
"A/V" (display): selects information
to display
95950005
EN