Inhaltsverzeichnis
Werbung
5.The frozen milk must be placed in a fridge to thaw naturally. If you need it urgently you can put it in warm water
and thaw. After thawing it, the breast milk can be stored in a fridge for 24 hours.
6.NEVER REFREEZE THE BREAST MILK AGAIN.
7.You can warm up gradually the frozen breast milk in warm water or using a bottle warmer.
8.NEVER WARM UP THE BREAST MILK IN MICROWAVE, BECAUSE YOU CAN DESTROY THE VITAL
NUTRIENS AND ANTIBODIES. The uneven heating can lead to too hot areas of the breast milk, which can
cause burns to your baby's upper digestive tract. Never place a frozen bottle with milk in boiling water, as this
may cause the bottle to burst/ break. Never pour boiling water directly into the feeding bottle. You should allow
the water to cool for about 20 minutes before filling the bottle.
VIII. CLEAN AND STERILIZE THE MANUAL BREAST PUMP
Clean and sterilize Your manual breast pump before using it for the first time and after every usage following the
listed instructions.
1.Disassemble completely the manual breast pump.
2.CAREFULLY take off and clean the silicone valve. If it gets damaged, the vacuum will not be able to be
created and the milk will not be expressed.
3.Wash all the parts with small amount of hot water and with a little bit of not aggressive detergent and wash
them thoroughly. You can also wash the parts in dishwasher only on the top rack.
4.In order to wash the valve, you can rub it gently between your fingers with some liquid detergent. Do not put
any objects in the valve as this may lead to damages.
5.Sterilize all the parts in steam sterilizer. For all the breastfeeding moms, which breastfeed every 2 – 3 hours,
we do not recommend to sterilize after each use. The excessive disinfection and cleansing can easily lead to
premature aging and reduce the life of the breast pump. It is recommended to thoroughly clean the stains and
sterilize once a day.
6.IMPORTANT! If you use the breast pump as a device for storing the breast milk, you will have to take care for
the disinfection of all the washable parts of the pump, otherwise the milk may go bad, as it is a product difficult to
store.
IX. STORING THE BREAST MILK PUMP
•Keep the manual breast pump away from direct sunlight, as the continued exposure may cause discoloration.
•Store the manual breast pump and its accessories in safe dry place, away from the reach of children.
X. TROUBLESHOOTING GUIDE
1. Lack of suction:
• Check if you have put all the parts correctly and if the silicone valve is placed tightly to the pump body opening.
• Make sure that the silicone massage pad is correctly placed and fits to the pump body and a perfect seal is created.
2. The breast milk cannot be expressed:
• Please, make sure that the breast pump is correctly assembled and that vacuum is created.
• Relax and try again.
3. Pain in the breast area when using the pump:
• Stop using the manual breast and consult with Your professional advisor for breastfeeding. If the pump is not detaching
easily from the breast, you can break the vacuum, by putting a finger between the breast and massaging pad or between the
breast and the pump funnel.
4. The breast milk is leaking down the massage pad:
• Take out, place and reattach the massage pad, in order to make sure that it is firmly fixed to the central down part of the
funnel.
• Try to lean a little bit forward.
5. Cracking and discoloration of the pump/ feeding bottle parts:
• Avoid any contact with antibacterial detergents or such with abrasive parts as they may lead to damage of the plastic parts.
The combination of detergents, cleansers, sterilizing solution, mild water, softened water and variable temperatures in
specific cases may lead to cracking of the plastic. If this occurs, please, do not use the product. The pump body and the
breast milk storage container is safe to be cleaned in dishwasher, but the food, left on the rest of the dishes may cause their
darkening. Follow the cleaning instructions exactly. Keep the product away from direct sunlight, as the prolonged exposure
may lead to discoloration of the plastic parts.
6. Lost or broken parts:
• For spare parts, please, contact authorized service center or the trade agent, from which you have bought the product. Do
not use such which are not approved or not supplied from the manufacturer.
Do not try to repair by yourself or modify the product, because this may endanger your health and the one of your child.
Content: Silicone and PP
PRODUCED FOR CANGAROO; Importer: Moni Trade LTD; Address: Dolo 1 str., Trebich, Sofia, Bulgaria
Tel.: 00359 2 936 07 90
12
Werbung
Inhaltsverzeichnis
