Troubleshooting Guide - CANGAROO ELEGANCE XN-D211 Gebrauchsanweisung

3.If you are storing freshly expressed milk, please, seal it, the breast milk can be stored for 10 hours in room
temperature 19 - 25°C.
4. Expressed breast milk can be stored in the refrigerator for up to 48 hours (but not in the door) or in the
freezer for up to 3 months.
5. Frozen breast milk must firstly thaw in the refrigerator naturally. If you need it urgently, put it in a kettle and
thaw it. After thawing, the breast milk can be stored in a refrigerator for 24 hours.
6. NEVER REFREEZE THE BREAST MILK.
7. The frozen breast milk can be heated gradually in warm water or in baby bottle warmer.
8.NEVER HEAT THE MILK IN A MICROWAVE AS THIS MAY DESTROY VALUABLE NUTRIENTS AND ANTIBODIES.
In addition, the uneven heating may cause hot spots in the liquid which could cause burns to your baby's
throat. Never immerse a frozen milk container in boiling water as this may cause it to crack/ split. Never put
boiling water directly into a feeding bottle, allow to cool for around 20 minutes before filling.
XII. CLEANING AND STERILIZATION OF THE PUMP
WARNING! DO NOT STERILIZE OR DIP INTO WATE THE PUMPING MECHANISM. CLEAN IT ONLY WITH DRY
SOFT CLOTH.
Clean and sterilize the parts of the pump coming in contact with your breasts and the breast milk before
initial use and after each use, follow the instructions below.
DO NOT WET OR STERILIZE PART 5 – THE TUBE CONNECTING THE PUMP BODY TO THE PUMPING
MECHANISM.
Sterilization method:
1.Pull the tube (5) from the Pumping body (9) and relocate it elsewhere. Separate all parts, 1, 2, 3, 4, 6, 7, 8, 10
then wash in warm soapy water and rinse thoroughly. Do not use antibacterial or abrasive
cleaners/detergents.
2.Sterilize ONLY the following parts 1, 2, 3, 4, 6, 7, 8, 10 in steam sterilizer or by boiling for 10 minutes.
 CLEANING SUGGESTIONS
1.Use steam sterilizer for sterilizing the pump. Boiling is not recommended. The first reason is that the product
is easy to damage, if exposed to improper sterilization. Second, this unscientific method of sterilization cannot
achieve the complete effect.
2. If you decide to use boiling as a method of sterilization, please, pour more water into the pot so that the
parts can be completely covered with water. Do not leave the product unattended during sterilization. Do not
boil for too long – maximum 10 minutes.
3. For the nursing mothers who breastfeed once every 2 – 3 hours, it is not recommended to sterilize and clean
after each use. Excessive disinfection and cleansing can easily lead to premature aging and reduce of the life of
breast pump. It is recommended to thoroughly clean the stains and sterilize once a day.
4. Store the parts in a clean container.
 IMPORTANT! If the breast pump is for the purpose of storage of the milk, you should take care of the
disinfection of all washable parts of the pump, otherwise the milk may go bad, as it is a product difficult to
store.
 WARNING! Before use you should make sure that the body of the breast pump, the piston, the valve and
the cover are dry.
 We recommend you not to sterilize the tube – part 5 in order to avoid accidental entry of water into the
pumping motor.
 If you use a steam sterilizer for cleaning of the parts of the pump, you should be careful not to enter in
contact with the heater of the sterilizer. If you use boiling as a method for sterilization, be careful not to enter
into contact with the bottom of the vessel in which you boil.
XIII. TROUBLESHOOTING GUIDE
1. Lack of suction:
• Check if you have assembled all parts correctly and if the valve is positioned correctly.
• Ensure that the silicone massage pad and the shield brace are fitted securely to the pump body and a perfect
seal is created.
• Check if you have placed the silicone valve firmly to the opening of the pump body.
16