Herzberg HG-5200 Bedienungsanleitung Seite 9

(1) Hole
(2) Throttle cable
INSTALLING THE METAL BLADE (F6)
1. Set the inner holder to the gear shaft and burn to fix with the attached L-shaped bar.
2. Put the blade on the inner holder with letters to the gear case and match correctly the hole of the blade
to the projection of the inner holder.
3. Set the outer holder to the gear shaft with the hollowed face to the blade.
ADJUSTING TH THROTTLE CABLE
1. after releasing the throttle lever pull the throttle wire. The normal
play is 1 or 2 mm when measured at the carburetor side end.
2. If the play is short or long take off the air cleaner cover loosen the
lock nut and adjust the play.(F5)
(1) Adjust nut
(2) Lock nut
4. Put the attached bolt cover on the outer holder and secure it with
the bolt (left screw) together with the spring washer and the
washer.
() Nut
(2) Spring Washer
(3) washer
(4) Outer holder
(5) Blade
(6) Gear shaft
(7) Bar
(8) Inner holder
(9) Gear case
INSTALLING THE NYLON CUTTER(OPTION) (F7)
1. Set correctly the inner holder and the outer holder to the gear
shaft.
2. Screws the attached bold (M8 Left) into the gear shaft and
secure it with the spanner.
3. Screw the nylon cutter into the bolt by fixing the inner holder with
the L-shaped bar and tighten it manually.
NOTE
Keep bolts and washers to install the blade carefully so as not to lose
them.