Herzberg HG-5200 Bedienungsanleitung Seite 14

AFTER 100 HOURS OF USE
MUFFLER
1. Remove the muffler insert a screwdriver into the vent and wipe away any
carbon buildup. Wipe away any carbon buildup on the muffler exhaust
vent at the same time.
2. Tighten all screws bolts and fittings.
3. check to see it any oil or grease has worked its way in between the clutch
lining and drum and if it has wipe it away using oil-free lead-free gasoline.
4. Remove the float cabin of the carburetor and clean the inside.
ADJUSTING CARBURETOR
IMPORTANT
A wrong adjustment may cause damage to your unit. If the engine does not
run well after adjusting the carburetor please contact the shop where you
purchased the product.
IDLE ADJUSTMENT SCREW (F17)
This is the screw to adjust the engine rotation when the throttle lever is set to the
MAINTENACE BEFORE STORAGE
1. Brushing off dirt form the machine check damage or stack of each part if
GEAR CASE
Supply multi-purpose grease at every 25 hours of use.
Remove the cutter holders to arrange for old grease
to exit.(F16)
lowest speed position. If you turn right (clockwise).
rotation increases and left (counterclockwise)
decreases. In case the blade continues to rotate
or engine stops when you return the throttle lever
completely to the original position make
readjustment.
(1) Idle adjustment screw
(2) High
(3) Low