Cutting Operation; Stopping The Engine - Herzberg HG-5200 Bedienungsanleitung

NOTE
When restarling immediately after stopping the engine move the choke lever to the open position.

CUTTING OPERATION

2. Open the fuel tank cock.(F9)
3. Move the choke lever to the closed position.(F9)
(1) Choke lever
(2) Fuel cock
(3) Close
(4) Open
(5) Close
(6) Open
4. Set the throttle lever to the starting position.(F10)
(1) Idling
(2) Starting (1/3-1/2 open)
(3) Full throttle
NOTE
When restarting immediately after stopping the engine move the throttle
lever to the idling position.
5. While holding the unit firmly pull out the starter rope quickly.(F11)
6. After the engine has started open the choke gradually.
7. Allow the engine to run for 2 to 3 minutes to warm up.

STOPPING THE ENGINE

1. Return the throttle lever to the idling position.
2. Push the engine switch button.
EQUIPPING THE SHAWL BAND(F12)
1. Equip the attached shawl band.(F12)
2. Turn on the engine return the throttle lever to the lowest speed
position and put the shawl band hook to the hanging part of
the machine.
3. Adjust the length of the shawl band so that the blade may be
parallel to the ground in the working position. In order to
prevent stack during operation turn up the extra part of the band
from the buckle.