Herzberg HG-5200 Bedienungsanleitung Seite 6

obstacles, which can be cleared away.
b. The area within a perimeter of 15m of the person using the brush cutter should be considered a hazardous
area into which no one should enter while the brush cutter is in use, and when necessary yellow warning
rope, warning signs should be placed around the work area. When work is to be performed simultaneously
by two or more persons. always check the presence and locations of others so as to maintain a distance
each person sufficient to ensure solely.
NOTES ON STARTING THE ENGINE
1. Take a careful look around to make sure that no obstacles exist within a perimeter of 15m or less around
brush cutter.
2. Place the body of the brush cutter onto the ground in a flat clear area and hold it firmly in place so as to
KICKBACK SAFETY PRECAUTIONS
A dangerous reaction may occur when the spinning blade contacts a solid object in the critical area. It is
called kick back. as a result, the operator can lose control of the unit. which can cause serious or fatal
injury.
Avoid kickback, observe the safely precautions below strictly.
1. Before beginning work, clear your working area and remove grasses around the obstacles.
2. When using your brush cutter do not grip other parts except the handles.
c. Make sure that there are no loose screws or bolts. fuel leaks, ruptures, dents, or
any other problems. which might interfere with safe operation. Be especially
careful to check that there is nothing wrong with the blades or with the joints by
which the blades are attached to the brush cutter.
d. Never use blades that are bent, warped, cracked, broken or damaged in
any way.
e. Keep the blade always sharp.
I. filling the cutting edges, keep the end corner sharp and round the root of the
edge.
g. Check the boll to fasten the blade and be sure the blade turns smoothly
without abnormal noise.
ensure that neither neither the blades nor the throttle come into
contact with any obstacles when the engine starts up.
3. Place the throttle into the idling position when starting the engine.
4. After starting up the engine. if the blades continue to rotate even
after the throttle has been moved fully back, turn off the engine
and check the throttle wire and other parts.