Maintenance - Herzberg HG-5200 Bedienungsanleitung

METAL BLADE USAGE
NYLON CUTTER USAGE
☆
Nylon cord consumes large power. Please note that the engine
50% as large as when using metal blade.
☆
Nylon cutter cut grass with the power of cord rotation. If you try to cut grass for the length of cord at one
time rotation speed becomes lower due to resistance and you cannot cut well. In case of large
resistonce get the nylon cutter away from grass once moke the rotation speed higher and cut a small
amount of grass at one time.
☆
If you try to cut grass by swinging the brush cutter in the reverse way (from left to right) scraps fly in the
direction away from the body. You can avoid getting your clothes dirty.

8.MAINTENANCE

AFTER 25 HOURS OF USE
Always cut by guiding the head from your right to left.
☆
A metal blade cut best up to the point 1/3 from the edge. Use
☆
that area for cutting shrubs tough and thick weeds. For cutting
young grass you can use up to 2/3 from the tip of blade.
☆
Adjust the engine speed according to the cutting objects. Cut
the young grass at middle speed and cut shrubs or tough and
thick weeds at high speed.
(1) For branches and frees
(2) For grass and weeds
(3) Direction of cutting
(4) Direction of rotation
IMPORTANT
Operating at low speed mokes it easier for grass weeds or twigs to
become caught up in the blades and also it mokes the shaft and
clutch wear down more quickly.
BLADE
☆ Sharpen each cutting edge and moke sure the bottom corner is
rounded.(F13)
☆ Do not cool the blade with water in case of using grinder. If may
cause cracks on blade.
rotation speed in operation should be