Electrolux GK78TSIPCN Benutzerinformation Seite 14

14 www.electrolux.com
you want to use. There are three modes:
Standard (activated automatically when
you activate the hob), Big Bridge and
Max Bridge.
To set the heat setting use
two left side control bars.
Switching between the modes
To switch between the modes use
sensor field:
When you switch between
the modes the heat setting is
set back to 0.
Diameter and position of the
cookware
Choose the mode applicable to the size
and the shape of the cookware. The
cookware should cover the selected area
as much as possible. Place the
cookware centrally on the selected area!
Place the cookware with the bottom
diameter smaller than 160 mm centrally
on a single section.
Place the cookware with the bottom
diameter larger then 160 mm centrally
between two sections.
.
100-160mm
6.2 FlexiBridge Standard mode
This mode is active when you activate
the hob. It connects the sections into two
separate cooking zones. The sides of the
zones which operate together in this
mode light up, and they are linked with
shorter illuminated lines. You can set the
heat setting for each zone separately.
Use two left side control bars.
Correct cookware position:
Incorrect cookware position:
> 160 mm