Klarstein Valdosta 2.0 Handbuch Seite 48

EN
48
Problem
Grease fire or
continuous excessive
flames above cooking
surface
Burner will not light using
ignitor.
Possible Cause
Too much grease
buildup in burner area.
Gas issues:
Trying to light wrong
burner.
Burner not engaged with
control valve.
Obstruction in burner.
No gas flow.
Vapour lock at coupling
nut to gas cylinder.
Coupling nut ad gas
cylinder valve not fully
connected.
Prevention / Solution
Turn off the gas supply at the
gas cylinder. Leave lid open
to allow flames to die down.
After cooling, clean food
particles and excess grease
from inside firebox area,
grease cup/pan/tray and
other surfaces.
See the instructions for lighting
the grill in the "Operation"
section.
Make sure valves are
positioned inside of burner
tubes.
Ensure burner tubes are not
obstructed with spider webs or
other matted, see "Cleaning
and Maintenance"section.
Make sure the gas cylinder
not empty, refer to "Sudden
drop in gas flow" (below).
Turn control knobs to "OFF"
and disconnect coupling nut
from gas cylinder. Reconnect
and retry.
Turn the coupling nut
approximately onehalf to
three-quarters.