Klarstein Valdosta 2.0 Handbuch Seite 42

EN
42
• Position the gas cylinder on the left side of your gas grill or place it in the gas
cylinder compartment inside the grill, keeping in mind that the bottle must be kept
away from heat and in a safe position.
• When ready to use your gas grill insert the regulator into the gas bottle valve and
tighten fi rmly.
WARNING
Risk of injury and material damage! Before attempting to light your gas
grill, follow all instructions, warnings and safety precautions described
in this manual.
• Check the hose before each use, searching for cracking, cuts or any abrasions. If
the hose is found to be faulty in any way do not attempt to use your gas grill.
• When changing your gas bottle ensures that there are no sources of ignition close
by i.e. fi res, cigarettes, naked fl ames etc. Make sure that the appliance is switched
off.
• Ensure that the hose is not subjected to twisting which will affect the gas fl ow when
installing your gas grill. Also the hose must not have undue tension and must not
touch any part of the gas grill which may be hot.
• Please choose fl exible hose whose heatproof higher than 80 °C.
• Flexible tube should be changed every 2 years. It's necessary to change the
fl exible tube when the national conditions require it.
How to Change a Gas Cylinder
Note: Close the gas cylinder regulator (no wrench is required!)
• The gas cylinder should have the following dimensions: 80 cm height and max.
35 cm width.
How to Connect a Gas Cylinder
• Turn the orange cap so that the arrow is pointing to the gap in the shroud.
• Remove the orange safety cap by pulling the lanyard out, then out. Do not use
tools. Leave the cap hanging.
• Check that the black sealing washer is fi tted inside the cylinder valve. Connect the
regulator to the valve.
• Turn the gas cylinder regulator clockwise and then operate the gas grill as
described.