Sanremo Treviso Bedienungsanleitung Seite 21

ENGLISH
Water connection
Connecting the water circuit
When installed, the boiler and heat exchangers are dry to avoid possible damage to the appliance caused by freezing.
1) The appliance must be fed with cold water only.
2) Vibration pump version (Treviso). Remove, rinse, fill and replace the tank, reinserting the hoses and closing the cap
3) Rotary pump version (Treviso LX). Connect the hose to the mains water supply, then to the water softener and the appliance. If
the mains pressure is higher than 0.6 Mpa (6 bar), you must install a pressure regulator with 0.6 Mpa (6 bar) maximum output
pressure.
Connect to the mains water supply in respect of national legislation.
N.B. Version TREVISO LX: a water softener is indispensable for correct appliance operation, best coffee in the cup and long life of the
components, since it removes lime and residues from the water that would otherwise shorten their life.
The company is relieved of all and any liability in the event of failure to comply with the above instructions.
Preliminary check
Before using the appliance, check that:
-
the plug is inserted properly into the mains power outlet.
- In the TREVISO LX and TREVISO LX 1500W version, the filling hose is correctly
connected to the mains water outlet and that the water tap is open; also check for
leaks.
With the steam tap (H) open, put the on/off switch (C) to the ON position and wait for the water
in the boiler to reach the maximum level set by the electronic control.
Wait for steam to come out the steam nozzle (H), then close the tap and, using the boiler
pressure gauge, check that the pressure has reached and maintains a value of 0.8:1 bar. If it
is not on this value, turn the adjusting screw on the pressure switch (+increase, - decrease).
Hot water
To dispense hot water, make sure that the boiler pressure gauge indicates a pressure of 0.8÷1.3 bar. Turn the tap knob (B) counter-
clockwise.
Take great care as there is a risk of scald burns.
Steam
Swivel steam nozzle. To dispense steam, just turn the knob (H) counter-clockwise. Take great care as there is a risk of scald burns.
Coffee
Insert the filter-holder (E) into the group head (D) turning the filter-holder counter-clockwise. Raise the lever (L), wait for the required
quantity of coffee to be dispensed and then lower the lever (L) to its original position.
Filter: After having dispensed the last cup of coffee the filter and filter-holder must be washed with water. If they are damaged, worn
or clogged, they should be replaced.
Drip tray and grid: The drip tray and grid should be removed frequently and coffee residues cleaned away.
Water softener: TREVISO LX – TREVISO LX 1500W the softener should be periodically regenerated according to the manufacturer's
directions given in the instruction booklet.
External housing: The external housing and the steel parts should be cleaned with sponges and soft cloths to avoid scratching. Only
use detergents that do not contain abrasive powders or solvents and do not use steel wool.
WARNINGS: when using the appliance it is recommended that the various instruments be kept under control, checking that they are
in the previously indicated normal working conditions.
The user must check that this is not due to:
- power failure or blackout
-
Version TREVISO LX – TREVISO LX 1500W no mains water supply or no water inside the boiler.
-
For the TREVISO (Vibration pump) version, ensure that there is water in the container.
USE
CLEANING
APPLIANCE MALFUNCTION
21