Removing The 5-Point Harness - KIKKA BOO VIAGGIO Gebrauchsanweisung

The more snugly the harness fits over your child's body, the better your child will be protected. Therefore avoid putting thick clothes on your
child under the belt. Open the harness buckle (press red button)For the safety of your child, before every journey in the car check that:
-the child safety seat is engaged on both sides with the ISOFIX connecter and that both green top tether are completely green;
- the child seat is firmly installed in the vehicle; the belt is not twisted;
-the Top Tether is tightly tensioned over the backrest of the car seat and the tension;
ADJUSTING THE HEADREST IN 5-POINT HARNESS INSTALLATION
12.
A correctly adjusted headrest ensures optimal protection for your child in the safety seat:
The headrest must be adjusted so that the shoulder belts are at the same level as your child's shoulders.
CAUTION! The shoulder belts must not run behind the back of the child or at ear height or above the ears.
The shoulder belts are adjusted as follows:
1. Loosen the 5-point harness of the child seat as much as possible. Back side of the child seat:
2. Press the button of the shoulder belt height adjuster at the rear of the seat shell and tilt the shoulder belt height adjuster towards you.
3. Slide the shoulder belt height adjuster to select the correct height of the shoulder belts and engage it in the position that fits for your child
by releasing the button.
GROUP I ADJUSTING THE BACKREST
13.
Find the recline handle which is under the seat shell.Pull it, can adjust the backrest angle posittion.

REMOVING THE 5-POINT HARNESS

14.
14.1 Loosen the 5-point harness 38 of the child seat as much as possible.
14.2 Press the button of the shoulder belt height adjuster at the rear of the seat shell and tilt the shoulder belt height adjuster towards
you. Move the shoulder belt height adjuster into the top position and fix the position by releasing the button of the shoulder belt height
adjuster. Loosen the 5-point harness of the child seat as much as possible. Unhook the shoulder belts on the back side of the child seat from
the connecting piece Snap the connecting piece in the provided storage.
14.3 Open the harness buckle (press the red release button) Roll the shoulder belts together and place them also into the storage
compartments.
14.4 Hold the metal plate vertically. Push it with the narrow side upwards through the belt slot closest to you into the seat shell from
above. Ensure by looking underneath the seat that metal plate is in a horizontal position and check the installation.
REFITTING THE 5-POINT HARNESS
15.
15.1 Take the harness buckle and hold the metal plate vertically. Push it with the narrow side upwards through the belt slot a to the seat
shell from above.
15.2 Pull the shoulder belts 08 and the strap loops of the shoulder pads through the slots.
15.3 Pull the strap loops of the shoulder pads onto the plastic extensions of the shoulder belt height adjuster .Tip: the strap loops of the
shoulder pads should be the lower loop.
15.4 Hook the shoulder belts 08 back onto the connecting piece . The left loop on the left arm of the connecting piece and the right loop
on the right arm.
CAUTION! Do not twist the belt.
INSTALLATION: GROUP II III ( 15-36 KG ) WITH VEHICLE BELT.
16.
16.1 Make sure removed the 5 point harness.
16.2 Have your child sit down in the child seat.
16.3 Pull out the vehicle seat belt and guide it in front of your child to the vehicle seat buckle.
16.4 Guide the diagonal seat belt section into the belt guider group II III A of the headrest untill it lies completely in the belt holder
and is not twisted. Make sure that the diagonal seat belt section runs over your child's shoulder bone, and not in front of his or her neck.
Tip! You can still adjust the height of the headrest again herein the vehicle.
16.5 Tighten the vehicle seat belt by pulling on the diagonal seat belt sectio.
ENGLISH