Velleman HAM202 Bedienungsanleitung Seite 10

3. Insert a microSD card (not included) in the card slot [F].
4. Close the cover [G] and slide it as indicated [H] to lock it.
5. To remove the SD card, slide the card slot cover [8] as
indicated [I] to unlock it.
6. Lift the cover [J].
7. Take out the microSD card.
6.4 Setting the Date and Time
To set the date and time in the alarm (for a correct timestamp on the
recorded video files), connect the alarm to your pc via the USB
port [7] and the included USB cable. The alarm automatically copies
the date and time from your pc.
6.5 Installing the Alarm
You can use the alarm free-standing on a horizontal surface, or you
can attach it to a wall. To mount against a wall, proceed as follows:
Remove the back cover from the alarm and screw it to the wall
1.
at 1.0–1.5 m above the ground [M].
Click the body of the alarm into place on the back cover and fix
2.
it with the screw.
7. Operation
Arming and Disarming the Alarm
• To arm the alarm, press the ARM button [13] on the remote
control. The alarm plays a confirmation tune to indicate that
arming is successful. Note that the alarm is only activated after a
delay of 30 seconds, to allow you to leave the area without
triggering the alarm.
When the alarm detects motion, the siren goes off and the camera
starts recording video after a delay of 5 seconds. These 5 seconds
allow you to enter the area again and disarm the alarm before it
goes off. For each motion detection, the camera records a
30 second video file.
• To disarm the alarm, press the CLR button [14] on the remote
control.
Muting the Alarm
If you want to mute the siren, proceed as follows:
Press the CLR button to disarm the alarm.
1.
V. 02 – 28/07/2014
HAM202
10 ©Velleman nv