General Configuration; Main Menu; Automatic Switch Back To Main Menu; Menu Activation - Audiotec Fischer CONDUCTOR Benutzerhandbuch

4.1 General Configuration
The "General Configuration" area is used for all the basic Menu Configuration and LED display (LED Configuration)
settings.
4.1.1 Main menu
This is where the CONDUCTOR's start menu, which is accessed immediately after the DSP is switched on, is
defined.
Volume Control, Signal Input selection, Sound Setup selection and Bluetooth Playback Control menu are available
for selection.
4.1.2 Automatic switch back to main menu
If the function is enabled, the CONDUCTOR switches back to the set "Main menu" after around 5 seconds, if an-
other menu was previously selected. If the function is disabled, the currently selected menu remains selected until
it is manually changed by briefly pressing the button.
4.1.3 Menu activation
This lets you enable and disable the volume controls as well as other menus. If a menu is disabled, it cannot be
selected by the CONDUCTOR.
Note: The "Volume Menu" is always enabled and can only be switched off by disabling all four volumes in the
"Volume Control Configuration" (see point 4.2).
An enabled menu can be recognized by a red cross in front of the menu name.
Note: The start menu set in the "Main menu" is automatically enabled.
4.1.4 LED brightness
This lets you set the brightness of the LED lighting. This is set to 70 % by default.
4.1.5 LED Dimming
This menu lets you configure the optional dimming of the LEDs. When this function is enabled, the LEDs are au-
tomatically dimmed by the configured value or switched off completely after 8 seconds of inactivity.
5 % - 75 % of LED brightness: The LEDs are dimmed by the set percentage based on the set LED brightness. A
dimming level of 50 % is set by default. The selection range may be restricted depending on the set brightness of
the LED lighting (LED brightness).
Example: LED brightness 50 %, LED dimming 50 %
The set LED brightness of 50 % is now dimmed by an additional 50 %.
Disabled: Switches the "LED dimming" off.
LEDs off: Switches the LED lighting off completely.
4.1.6 Installation orientation
If the installation situation prevents the CONDUCTOR from being installed in the 12 o'clock position, it can also
be rotated in 30° steps for installation. The LED display can then be adapted to the installation position in the DSP
PC-Tool software (see page 22, "Assembling the CONDUCTOR").
29