Installation Instructions; Assembling The Conductor - Audiotec Fischer CONDUCTOR Benutzerhandbuch

2. Installation instructions

2.1 Assembling the CONDUCTOR

i.
46
Slot
ii.
Connection
cable
iii.
iv.
v.
22
Cutting out the mounting slot
To ensure a safe and professional assembly, the cutout must not be more than
40 mm in size. Please make sure that the space between the CONDUCTOR
and other parts, such as switches, control elements, etc., is adequate with a
sufficient installation depth. This is particularly important if installation slots
need to be cut out. All the data on the installation depth and the diameter
of the CONDUCTOR is provided in the technical data in these instructions.
Please make sure that the contact surface is as level and stable as possible.
Routing and connecting the CONDUCTOR connection cable
CONDUCTOR
cable
Route the 4.8 m connecting cable and guide it through the installation opening
from the rear. Then connect the cable to the 20 cm CONDUCTOR cable.
Inserting the CONDUCTOR
Press the housing evenly into the hole.
IMPORTANT: To avoid damage, never push on the aluminum button in the
centre of the CONDUCTOR during assembly, only on the surrounding plastic
housing.
Use the 12 o'clock marking on the housing (see fourth figure on the left) as a
guide to align the CONDUCTOR.
If the installation situation prevents the CONDUCTOR from being installed in
the 12 o'clock position, it can also be rotated in 30° steps for installation. The
LED display can then be adapted to the installation position in the DSP PC-
Tool software (see page 29, "Installation orientation").
The plastic housing should lie flush once you have moved the CONDUCTOR
to its final installation position.