Installation - Icy Box IB-1124L-C3 Handbuch

Installation

1. Connect DockingStation and host computer with the included USB 3.0 cable.
2. Connect the DockingStation with a household EU 230 V power socket by using the wall
power adapter.
3. Switch on the DockingStation by pressing the ON/OFF Button at the rear side of the
DockingStation.
4. Gently insert one 2.5" or 3.5" SATA I/II/III SSD or HDD into the DockingStation. Please
pay attention to the right direction of the SATA drive.
5. If the SATA drive is installed correctly, the operating system will recognize the drive
immediately and automatically.
Hint: Drives must be initialised and have active partitions so that they are immediately
recognised as volumes by the operating system. If this is not the case, initialise the drive in
the disk management of your operating system.
6. The SATA drives can be connected and disconnected while the computer is running.
ATTENTION! Please await write and read operation before disconnecting the drive from
the DockingStation to avoid data loss!
Manual IB-1124L-C3