Electrical Connection; Warning; Connection To The Electrical Supply Mains; Equipotential System - Unox ChefTop XC314 Bedienungsanleitung

ChefTop™ ChefTop™
To fix the front part of the hood to the oven use the
proper self-tapping and self-drilling screws (issued with
the hood).

3. ELECTRICAL CONNECTION

3.1 WARNING

The connection to the electrical power supply system
must be carried out according to the current local regula-
tions.
Before connecting the appliance, make sure that the volt-
age and the frequency correspond to those stated on the
data plate of the appliance.
The appliance must be placed in such a way that the con-
necting plug to the network can be easily reached.
Place an omni-polar switch between the appliance and
the network in such a way that it will be easily accessi-
ble after the installation. The contacts of this switch must
have a minimum opening distance of 3 mm and the switch
must have an appropriate input (for example: thermal-
magnetic switch).
The use of a safety switch for fault current is suggested.
When the appliance is working, the power supply voltage
must not diverge from the value of the nominal voltage,
indicated on the data plate, by more than ± 10%.
ENGLISH
5
3.2 CONNECTION TO THE ELECTRICAL SUPPLY
MAINS
Simply plug the oven to the proper outlet (the outlet has
to be suitable for the issued plug)
The replacement of the cable must be done by author-
ised personnel.
The appliance must be connected to the ground line of
the network.

3.3 EQUIPOTENTIAL SYSTEM

The appliance must be included in an equipotential system
whose efficiency must be properly checked according to
the current laws. This connection must be done between
different appliances through the terminal marked with
the symbol: (simbolo morsetto equipotenziale)
The equipotential conductor must have a minimum sec-
tion of 10 mm2.

4. WATER CONNECTION

4.1 WARNING
It is necessary to place a mechanical filter and a shut-off
valve between the water system and the appliance.
As required by current laws, the appliance is equipped
with 2 metres of pipe, the respective pipe fitting (3/4")
with non-return valve and mechanical filter.
Before connecting the water pipe to the appliance please
let some water flow to clear the pipe of any obstruc-
tions.
The water used in the appliance must have a pressure
value between 1 and 3 bar and a maximum temperature
of 30°C.

5. DRAIN CONNECTION

5.1 WATER DRAIN

You find the extract condensate drain on the rear of the
hood. It has to be connected to an open or trapped drain
through a rigid or flexible pipe. The diameter of the pipe
cannot be smaller than diameter of the drain connection.
The length of the pipe cannot be longer than one metre.
Tighten the pipe with a hose clamp to avoid the pipe be-
coming disconnected.
Avoid reductions in diameter and tight bends along the
whole length of the waste pipe run.
ENGLISH