BALDR B0359WST2H2R Bedienungsanleitung Seite 19

Problem
"HH.H/LL.L"
display in indoor
and/or outdoor
temperature
If your BALDR product does not operate properly after trying the trou-
bleshooting steps, please contact the seller on your order page or
shoot an email to: service@baldr.com.
PLACEMENT INSTRUCTION
BALDR sensors are sensitive to surrounding environmental condi-
tions. Proper placement of both the main unit and outdoor sensor
are critical to the accuracy and performance of this product.
Main Unit Placement
Place main unit in a dry area free of dirt and dust. To help ensure
an accurate indoor temperature measurement, be sure to place
the Main unit away from heat sources or vents.
Outdoor Sensor Placement
Sensor must be placed outside to observe outdoor conditions.
Sensor is water resistant for water splashes and is designed for
general outdoor use, however, to extend its life place the sensor in
an area protected from direct weather elements. The best location
is 1.2 to 2.4 meters (4 to 8 feet) above the ground with permanent
shade and plenty of fresh air to circulate around the sensor.
Important Placement Guidelines
• The distance between main unit and transmitter should be at least
1.5~2 meters (5~6.5 feet) away from any interfering sources such
as computer monitors or TV sets.
Possible Solution
If the temperature is higher than the detection
range, "HH.H" will display on screen for indi-
cation; if lower than the detection range,
"LL.L" will display on screen for indication.
19