BALDR B0359WST2H2R Bedienungsanleitung Seite 18

Problem
Outdoor reading
is flashing or
showing dashes
No outdoor
sensor reception
Inaccurate
temperature/
humidity
Possible Solution
2.
Make sure the CH 1-2-3 switch on both
units match.
3.
Reload batteries in main unit.
4.
Reload batteries in outdoor sensor.
5.
Let both units sit within a couple feet of
each other for a few minutes to gain a
strong connection before taking sensor to
outdoor area.
1.
Reload the batteries of both outdoor sensor
and main unit. Please refer to the SENSOR
SETUP section.
2.
Relocate the main unit and/or the outdoor
sensor. The units must be within 100m
(328ft) of each other.
3.
Make sure both units are placed at least 0.9
m (3 ft) away from electronics that may
interfere with the wireless communication
(such as TVs, microwaves, computers, etc).
4.
Use standard alkaline batteries. Do not use
heavy duty or rechargeable batteries.
NOTE: It may take a few minutes for main
unit and sensor to synchronize after batter-
ies are reloaded.
Make sure both the main unit and sensor are
placed out of direct sunlight and away from
any heat sources or vents.
18