LauraStar SMART I WHITE Bedienungsanleitung Seite 4

Vertical smoothing out
H
Suspend the item of clothing on a hanger or on the vertical support bracket
(available on www.laurastar.com or at your approved Laurastar retailer). Moving
the iron from top to bottom, lightly touch the fabric using short bursts of steam.
Note: almost all fabrics smooth out easily, with the exception of cotton, linen
and certain silks.
If a fabric is difficult to smooth out, place it on the ironing board and iron it
normally.
WARNING: Do not iron or vertical steam clothes that are being
worn. Do not point vertical steam in the direction of people or pets.
Filling
bip
Empty water indicator light (20) and warning tone
A warning tone sounds and the empty water indicator light (20) flashes to signal
LAURASTAR
that there is no water left in the steam generator's reservoir.
As soon as the warning tone sounds, the steam stops and you must refill the
water reservoir (11).
A
How to fill the water reservoir (11)
B
• Remove the water reservoir (11) from its place. Take off the reservoir lids.
• Fill the reservoir with tap water. The filtered water must reach the MAX level.
• Close the lids and put the reservoir back in its place on top of the steam
generator (15).
MAX
H
A
B
- 11 -
Maintenance
To extend the life of your appliance, we recommend that you rinse
the steam generator and clean your iron every month or after every
10 hours of ironing.
WARNING: the appliance should be UNPLUGGED, OFF and
A
COLD before cleaning. Switch off and unplug the appliance.
Allow your appliance to cool down for at least 2 hours.
Always make sure your appliance is cold before cleaning !
NOTICE! Only rinse the appliance with water. NEVER use descaling
products or other chemical products.
B
Cleaning the iron (2)
If the iron's soleplate is dirty, use the cleaning mat in accordance with the
instructions. This can be obtained at www.laurastar.com or from your
approved Laurastar retailer.
Stubborn stains can be cleaned using an abrasive dishwashing sponge.
After completing this operation, remove the aluminium oxide present under
the soleplate by cleaning it with a damp cloth.
C
Clean the steam holes in the iron's soleplate as soon as they become blocked
up or calcified. Clean the holes using the appropriate tool. This can be obtained
at www.laurastar.com or from your approved Laurastar retailer.
Anti-scale filter change (13)
The anti-scale filter has to be changed when the granules are completely
brown.
E
• Remove the water reservoir (11) from its place. Take off the water reser-
voir lids. Remove the anti-scale filter (13).
• Dispose of the filter (13) in the regular houshold garbage and rinse the
D compartment. Install a new anti-scale filter in the water reservoir.
• Fill the reservoir with tap water. The filtered water must reach the MAX
level. Then put the reservoir back in its place on top of the steam generator
(15).
F
Note: you can wash the plastic elements of the water reservoir (11) in
the dishwasher.
F
MAX
A
B
C
D
- 12 -
EN
EN
FR
DE
NL
IT
ES
PT
TR
E
RU
CN
AR