Technical Design Features - EMPHASER G5 Serie Einbau & Bedienungsanleitung

Congratulations!
On your purchase of this sophisticated EMPHASER ECP-G5 2-way component system . If you plan
on installing the ECP-G5 component system by yourself, please read the following instructions
carefully before you attempt the installation . For any further information about this product, please
contact your EMPHASER dealer .

teChnICal desIgn Features

MId/WooFer
■ 13 CM EURO-DIN ALUMINUM CAST BASKET
■ 16 OZ . STRONTIUM-FERRITE MAGNET
■ WOVEN BLACK KEVLAR™ CONE
■ NBR NITRILE RUBBER DOUBLE-ROLL EDGE
■ PROGRESSIVE BLACK NOMEX™ SPIDER
■ 2-LAYER CCA-WIRE VOICE COIL
■ 30 MM POLYIMIDE VOICE COIL FORMER
■ VENTED CAVITY BELOW SPIDER
■ VENTED & EXTENDED CENTER POLE
■ JACKETED TINSEL LEAD WIRES
tWeeter eCp-g5
■ 25 MM ALUMINUM DOME TWEETER
■ CCA-WIRE VOICE COIL ON AL-FORMER
■ NDFEB NEODYMIUM MAGNET MOTOR
■ CAST ALUMINUM TWEETER HOUSING
■ LOW VISCOSITY FERROFLUID
CrossoVer eCp25-g5
■ 4-STEP TWEETER ATTENUATION
■ GLASFIBER EPOXY CIRCUIT BOARD
■ MKP CAPACITOR / MOX RESISTORS
■ HPCCR LAMP TWEETER PROTECTION
8