Husqvarna LC 141iV Bedienungsanweisung Seite 19

To operate LC 141C
To select an approved cable (LC 141C)
Note:
For the UK market, use only the 16M extension
cable that comes with the product. For all other markets,
refer to the information below.
If extension cables are used, these must comply with the
minimum cross-sections in the table below:
Voltage
220-240V/ 50Hz
220-240V/ 50Hz
• Mains cables and extension cables are available
from your local approved service agent for
Husqvarna outdoor products.
• Only use extension cables specifically designed for
outdoor use and which conform to one of the
following specifications: Ordinary rubber (60245 IEC
53), Ordinary PVC (60227 IEC 53) or Ordinary PCP
(60245 IEC 57)
• If the cable is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
To start the product
1. Connect a power cord to the socket below the
handle.
919 - 010 -
Cable Cross sec-
length tion
2
Up to 20 m 1.5 mm
2
20–50 m 2.5 mm
2. Put the power cord in the power cord holder. Refer
To use the power cord holder (model LC 141C) on
to
page 9 .
3. Stay behind the product.
4. Loosen the start inhibitor.
5. Push the motor brake handle in the direction of the
handlebar.
19