Husqvarna LC 141iV Bedienungsanweisung Seite 18

To use the drive on the wheels
• Model LC 141iV. Pull the drive bail in the direction of
the handlebar to start the drive.
• Press + and - on the control panel to set the drive
speed in 4 steps.
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
To use the SavE function
The product has a battery saving function (SavE) that
gives longer operation time.
1. Press the SavE button (A) to start the function. The
green LED comes on.
2. Press the SavE button again to stop the function.
The green LED (B) goes out.
The SavE function stops automatically if the ground
conditions make it necessary to have a higher output.
The SavE function starts automatically when the ground
conditions lets it.
High load function
When the product cuts long or wet grass, the motor
automatically increases rpm. The motor goes back to
standard mode when high load is not necessary.
To stop the product
The product stops automatically if you do not operate it
for 10 minutes. Always turn the safety key to 0 before
you let the product out of view.
18
A
B
1. Release the motor brake handle to stop the motor.
2. Press the ON/OFF button (A) on the control panel
and the green LED (B) goes out.
B
3. Open the battery lid and turn the safety key to 0.
4. To remove the battery, press the 2 release buttons
and pull out the battery.
5. Charge the battery if it is weak. For more
To charge the battery on page 16 .
information, see
A
919 - 010 -