Levoit LV600HH Bedienungsanleitung Seite 17

TROUBLESHOOTING (CONT.)
Problem
Water visibly leaks from the
humidifier.
A puddle of water forms
around the humidifier.
Mist is not warm after
pressing .
Incorrect humidity
percentage is displayed.
The humidifier does not
respond to the remote.
If your problem is not listed, please contact
Possible Solution
Stop using the humidifier and see
(page 13) before using again. If the humidifier continues
leaking, contact Customer Support
Run the humidifier on a lower mist setting.
Open a window to ensure proper airflow for your humidifier,
or move the humidifier to a more well-ventilated room.
Make sure the water tank is properly in place (see
Started, page 9).
When replacing the water tank, wipe off excess water from
the water tank and base.
Stop using the humidifier and see
(page 13) before using again. If the humidifier still leaks,
contact Customer Support
Allow the humidifier to heat up for about 15 minutes to
produce warm mist.
Clean the heating element of the humidifier (see
Things Clean, page 14).
The room may be larger than the humidifier's effective
range. Move to a room smaller than 40–70 m² / 430–753 ft².
Moisture may have built up inside of the humidity sensor.
Turn off the humidifier and allow the sensor to air dry. Make
sure the nozzles are facing away from the sensor.
Move remote control to within 4.8 m / 16 ft of the humidifier.
Remove the plastic tab from the battery compartment.
Change the battery (see
Battery, page 15).
Customer Support
Preventing Water Leaks
(see page 18).
Preventing Water Leaks
(see page 18).
Replacing the Remote Control
(see page 18
EN
Getting
Keeping
).
17