Troubleshooting - Ayce B0012 Gebrauchsanweisung

TROUBLESHOOTING

The following cases may not always be a malfunction, please check suggestions
below before asking for service.
Trouble Analysis
Does not run
1. If the protector trip or is blown.
2. Please wait for 3 minutes and start again, protector device may
be preventing unit from working.
3. If batteries in the remote controller are exhausted.
4. If the plug is not properly plugged in
Runs for a short while
only
1. If the set temperature is close to room temperature, you can
lower the set temperature.
2 . Air outlet is blocked by obstacle. Take the obstacle away.
Runs but not cooling
1. If the door or window is open
2. If there is another appliance heat-working .like heater or lamp,
etc.
3. The air filter is dirty, please clean it.
4. Air outlet or intake is blocked.
5. Set temperature is too high.
Water leak during
moving
1. Drain the condensate before moving.
2. To avoid water leakage,
Does not run
and water full
1. Pull out the rubber pug to drain water.
indicator"E4"
2. If it is often in this state, please contact qualified service technical.
Before claiming repair, check the machine as follows:
Failures Causes
Power supply failure:
Machine fails to
1.Not plugged;
start up
2.Plug or socket damaged;
3.Fuse broken.
Machine
TIMING shut down or set
automatically
temperature reached.
stops.
1. Room temperature lower than set
No cold air
temperature;
under COOLING
2. Machine enters into anti-frost
mode
protection.
1.Indoor temperature higher than set
No hot air under
temperature;
HEATING mode
2.Defrosting
3.Cold-air protection
LED displays Room temperature sensor fails or
failure code "E2" damaged.
LED displays The evaporator coil sensor fails or
failure code "E3" damaged.
LED displays
Water-full warning.
failure code "E4"
LED displays The condenser coil pipe sensor fails
failure code "E5" or damaged.
80 | 81
GB
Solutions
1. Plug in;
2. Replace the power cord or socket;
3. Replace the fuse by service provider
Restart or wait for auto-switch.
1. This is a normal phenomenon, the
machine will auto-switch while the
room temperature is higher than the set
temperature;
2. The machine will auto switch after anti-
frost protection is over.
This is a normal phenomenon,
the machine will auto switch
while the room temperature is
lower than the set temperature,
or after the defrosting ends, or
after cold-air protection is over.
Replace theroom temperature sensor.
Replace the evaporator coil pipe sensor.
Drain out the water.
Replace the condenser coil pipe
sensor.