kafer ETC536 Bedienungsanleitung Seite 34

the receiver receives the signal from the transmitter (transmitter and
receiver are now connected).
Connected: Once the transmitter and receiver are connected (the
icon will start to flash once every 3 seconds), the temperature values of
oven and meat sensors will be shown on the screen (Fig.6B).
Alarm Temperature
Meat Temp. Meat Temp.
Meat Temperature
Fig.6A – Before connection Fig.6B – After connection
b). Turn off:
Manually: To turn off the receiver manually, press button. The screen
will shut off and enter stand-by mode.
Note: This shut-off operation is invalid while the receiver is searching
for a signal (i.e. the icon is STEADY on screen.
Auto off: While the meat temperature (meat sensor) is lower than
50°C/122°F without any obvious temperature change (temperature
change <1°F), and there is no operation (timer is stopped and no button
is pressed) for about 10 minutes (±1 minute), the unit will enter stand-by
mode automatically.
Shut off signal from transmitter: While the transmitter is shutting
off, the transmitter will transmit a signal to the receiver, and the
receiver will shut down (enter stand-by mode) simultaneously.
34