Operation Introduction; Before Using; Cooling Operation; Dehumidifying Operation - Beko BP207C Bedienungsanleitung

7. Operation introduction

Before starting operations in this section:
1) Find a place where there is power supply
nearby.
2) As shown in Fig. 2 and Fig. 2a, install the
exhaust hose, and adjust the window
position well.
Fig. 2
3) As shown in Fig. 6, connect drain hose well
(only for using heating model);
4) Insert the power cord into an grounded
AC220~240V/50Hz socket;
5) Press the POWER button to turn on the air-
conditioner.

7.1 Before using

Notice:
– Operation temperature range:
Maximum
cooling
DB/WB (°C) 35/24
Maximum
heating
DB/WB (°C) 27/---
Local air-conditioner / User Manual
Check up whether the exhaust hose has been
mounted properly.
–
–
–
–
–

7.2 Cooling operation

Fig. 2a
–
–
–

7.3 Dehumidifying operation

–
–
Minimum
cooling

7.4 Fan operation

18/12
–
–
Minimum
heating
7/---
Cautions for cooling and dehumidifying
operations:
When using functions on cooling and
dehumidifying, keep an interval of at least
3 minutes between each POWER.
Power supply meets the requirements.
The socket is for AC use.
Do not share one socket with other
appliances.
Power supply is AC220-240V, 50Hz
Press the "Mode" button till the "Cool" icon
appears.
Press the "∧"or" ∨"button to select a
desired room temperature. (16°C-31°C)
Press the "Fan Speed" button to select
wind speed.
Press the "Mode" button till the
"Dehumidify" icon appears .
Automatically set the selected temperature
to current room temperature minus 2°C.
Automatically set the fan motor to LOW
wind speed.
Press the "Mode" button till the "Fan" icon
appears.
Press the "Fan Speed" button to select
wind speed.
25 / EN