Initial Use; Use; Ir Heat / Ir Heat Massage; Massage - Beurer MG 40 Gebrauchsanweisung

7. Initial use

Use the sliding switch to select the desired function:
Position
0 Off
M Vibrational massage
W IR heat for deep results
W + M IR heat massage

8. Use

8.1 IR heat / IR heat massage

Push the switch to 'W' to heat up the infrared area. This
now starts to light up. After a few minutes, it is heated up
and ready for use.
Important: If the infrared area is heated up for a relatively
long period without any skin contact, you may find the
temperature uncomfortably high. Before application,
please therefore always check the temperature of the in-
frared area with your fingertips. Switching off the infrared
heat briefly can reduce the temperature.
When the temperature of the infrared area is correct, set
the switch to 'W + M'. You can now start the infrared heat

massage.

All parts of the body can be reached easily thanks to the
pivoted joint of the massaging head and the possibility
of adjusting the angle of the handle. The handle can be
adjusted to 4 different settings by pressing the knob (Fig.,
no. 2).
8.2. Massage
Without exerting pressure, massage using slow, circular movements. Keep the skin taut to achieve
optimum results.
Pictures are showing ideal massage directions:
➀
To intensify the massage, we recommend the following massage heads:
➀ Brush fitting:
➁ Knobbed fitting 2: for intensive and localised deep massages - particularly soothing after physical
➂ Knobbed fitting 1: for intensive massages to relieve muscle pain and tension
➃ Tapered fitting:
Without the head, the massager is mainly used to massage sensitive parts of the body and to gener-
ate IR heat.
➁
for intensive skin massages - very pleasant, circulation - stimulating effect
exertion
for intensive and localised deep massages - particularly soothing after physical
exertion
front of body
➂
13
back of body
➃