Intended Use; Safety Informations - Zoofari IAN 306235 Gebrauchsanweisung

Congratulations!
With your purchase you have decided on a
high-quality product. Get to know the product
before you start to use it.
Carefully read the following instructions
for use.
Use the product only as described and only
for the given areas of application. Keep these
instructions safe. When passing the product
on to a third party, always make sure that the
documentation is included.
Scope of delivery (Fig. A)
1 x Bird feeder
1 x Roof (1)
1 x Hanging cord (1a)
1 x Feed tray (2)
1 x Feed dispenser (3)
1 x Threaded stand rod (4a)
1 x Extension rod (4b)
1 x Ground stake rod (4c)
1 x Hook (5)
1 x Allen wrench key (6)
1 x Instructions for use
Technical data
Dimensions (with stand rod):
approx. 20 x 170cm (Ø x H)
Date of manufacture (month/year):
08/2018

Intended use

This product is meant for private use as a bird
feeder for wild birds.

Safety informations

• Only use the product for its intended purpose.
• This product is not a toy. Never leave children
unsupervised with the product.
• Never leave children unsupervised with the
packaging material. There is a risk of suffoca-
tion.
• Check the hanging loop regularly. The product
can only be used in perfect condition.
• The product is not a toy! Make sure that no
one, especially children, climbs up on the
product. The product can fall over.
• Make sure that the product is securely mount-
ed and set up in order to prevent accidental
falling or tipping of the product.
Set-up instructions
Choose a safe place that is protected from the
interference of cats and other animals. Set up
and hang the product in such a way that there is
no risk of injury, especially to playing children,
from the product or falling leftover feed. Fasten
the product securely.
Hanging the product
1. Screw together the roof (1), feed dispenser
(3), feed tray (2), and hook (5) as shown in
Figure B.
2. Set the appropriate length for the product by
loosening the screws on the hanging cord
(1a) with the Allen wrench key (6) (Fig. C).
3. Twist the screws tight again, once you have set
the correct length.
4. Hang the product in a location protected
against the wind.
Using the product stand
1. Screw together the stand rod (4a) and exten-
sion rod (4b), and the extension rod (4b) and
ground stake rod (4c) as shown in Figure D.
Important! Ensure that the individual elements
are screwed together in the correct order (4a)/
(4b)/4c) (Fig. E).
2. Screw the product together as shown in Fig. B.
Do not use the hook in this instance.
3. Screw the stand rod onto the underside of the
product (Fig. F).
4. Push the product into the ground in a place
where the ground is solid and the area is
protected against wind (Fig. G).
Note: Remove the hanging cord by pulling the
opened hanging cord out of the roof completely.
Filling
Twist the roof (1) of the feed dispenser (3) and
fill the product with feed.
GB/IE 7