Technical Data; Intended Use; Safety Instructions - Zoofari 378745 2107 Gebrauchsanweisung

Congratulations!
You have chosen to purchase a high-quality item.
Familiarise yourself with the item before using it
for the first time.
Readthefollowinginstructionsfor
usecarefully.
Only use this item in the manner described and
for the purpose for which it is intended. Store
these instructions for use carefully. When passing
the item on to third parties, please also hand
over all accompanying documents.
Packagecontents/partslist
(Fig.A)
1 x bed area (1)
1 x sun roof (2)
2 x long rods (3)
2 x cross rods (4)
4 x feet (5)
4 x long connecting rods (6)
1 x short connecting rod (7)
4 x connectors (8)
2 x triangle connectors (9)
1 x instructions for use
1 x quick guide
Technicaldata
Dimensions: Bed area: approx.
106 x 20 x 75cm (W x H x D)
Total dimensions (bed area and sun roof):
approx. 106 x 85 x 75cm (W x H x D)
Max. capacity: 60kg
60
Date of manufacture (month/year):
01/2022
Intendeduse
The product is not intended for commercial use.
The product can be used as an indoor and
outdoor bed for dogs.
8 GB/IE
Safetyinstructions
Important:Readtheseassemblyinstruc-
tionscarefullyandkeeptheminasafe
place!
Riskofdeath!
• Never leave children unattended with the pack-
aging materials. There is a risk of suffocation.
• Keep children away from the product.
• The product is not a toy or a climbing ap-
paratus! Make sure that persons, especially
children, do not stand on the product or pull
themselves up on it. The product can topple
over.
Riskofinjury!
• Make sure the product is properly stabilised
before using it!
• Place the product on a solid and level surface.
Do not place near stairs.
• Do not place hazardous items, such as can-
dles, on or near the product.
• Check the product regularly for wear. Check
regularly to make sure all connections are
tight! The product should only be used if it is in
perfect condition!
• The product may only be used for its intended
purpose.
• Do not exceed the maximum carrying capacity.
Assembly
1. Remove the packaging and lay all the parts of
the product out on the floor (Fig. A).
2. Put the long rods (3) and the cross rods (4)
through the loops on the bed area (1).
3. Connect the ends of the long rods and the
cross rods with a connector (8) each (Fig. B).
Note: See Figure B. The small opening to insert
the sun roof must be facing upwards.
4. Put a foot (5) under each of the connectors
(Fig. C).
The dog bed is now completely assembled.
5. Slide the long connecting rods (6) through the
loops on the sun roof (2) (Fig. D).
6. Put the short connecting rods (7) in the centre
of the sun roof and put each of the ends of
the connecting rods in a triangle connector, as
shown in Figure E.