Teka GFG2 Bedienungsanleitung Seite 16

EN
 Do not allow grease to accumulate in any part of the extractor,
especially in the grease filters as this COULD PRODUCE A
FIRE RISK!
 The grease filters and the internal part of the extractor must be
cleaned at least once a month depending on how often the
extractor is used. Note that grease is deposited in the extractor
when cooking, whether it is switched on or not.
 We recommend the use of gloves and caution when cleaning the
inside of the extractor.
Repairs
 If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
 Do not switch on the extractor if the supply cord is worn or has
cuts or if there are signs of deterioration around the control
panel.
 If the LED module is malfunctioning, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
 If the extractor stops working or functions abnormally, unplug it
from the mains and contact the technical service.
Description of the appliance (Fig. 1-3)
A Motor controls, three speeds:
Low
High
Intensive
B switch
Light independent from motor
commands
C h by means of LED lamp
Lig ting
D Filter located over cooking area, easily
withdrawn for cleaning
E Frame and filter support
F Possibility of incorporating activated
charcoal filter (fig.2)
G-H Anti return tabs to be located in the outlet
mouth, locating their ends in the holes
provided (fig.2).
Instructions for use
By pressing the buttons ("A", "B") shown in
figure 1, you will be able to control the
functions of the extractor.
Two achieve better extraction, we recommend
switching on the extractor a few minutes
before starting to cook (3 - 5 minutes) so that
the air flow is continuous and stable when
extracting the fumes.
Likewise, keep the extractor switched on for a
few minutes when cooking is complete to allow
all fumes and odours to be expelled.
16