Led Lights; First Time Use - iStorage diskashur DT2 Schnellstartanleitung

Quick Start Guide
Thank you for purchasing the iStorage diskAshur DT
a default Admin PIN of 11223344 and although it can be used straight out of the box with the default Admin PIN,
for security reasons, we highly recommend that a new Admin PIN be created immediately
instructions under the heading 'Changing the Admin PIN'.

LED LIGHTS

- Standby State/Locked
- User Mode/Unlocked
- Admin Mode
Alphanumeric
Keypad
LOCK
SHIFT
UNLOCK

First Time Use

To setup the diskAshur DT
Next, connect the supplied AC adapter to the back of the drive and a mains power outlet. Once connected press the
power switch on the back of the drive to the ON position, your diskAshur DT
all security components are working properly each time the diskAshur DT
through 3 test stages, blinking in sequence RED,
RED (Standby State) on a successful test. Any test failure will force the diskAshur DT
automatically resume the self-test without affecting the security characteristics or any data stored on the drive.
With your diskAshur DT
1. In Standby State (solid
the default Admin PIN '11223344' and then
press the 'UNLOCK' button.
Downloaded from www.Manualslib.com
, insert the supplied USB cable to the back of the drive and connect to your computer.
2
powered on and connected, follow the instructions in the table below to unlock.
2
RED LED), enter
manuals search engine
. Your diskAshur DT is preformatted in NTFS and shipped with
2 2
USB 3.1
PORT
DESK
LOCK SLOT
2
is powered on. The LEDs will go
2
GREEN and BLUE, followed by two
GREEN and
several times and then to a solid
changing to a blinking
solid GREEN
by following the
diskAshur DT rear view
2
MAINS
POWER
ON/OFF
SWITCH
undergoes a rapid self-test to verify
GREEN blinks and then to
to securely reset itself and
2
BLUE LEDs will alternately blink
BLUE
GREEN and finally to a
LED.
AIR
VENT
LED
3