Operation; Manual Operation - Klarstein Basel Baseline Bedienungsanleitung

EN
26

OPERATION

Note: The appliance can be operated either by the switches located on the top right
hand side of the fireplace or by the supplied remote control.

Manual Operation

• This is done by operating the switches located at the top right hand side of the
firep. The standby rocker switch must first be switched on, the fireplace will beep to
indicate that it is powered up.
• Press the [O/I] button once to turn on the appliance and fire effect. A red indicator
light will show to indicate that the fireplace is ON.
• Press the [O/I] button for 3 seconds this will operate the colour flame mode.
Hold the button down until the desired colour flame is obtained, and there will be
7 colours available.
• Press the [POWER] button once for the low heat setting (1000 W). Press the button
a second time for the high heat setting (2000 W). Press the button a third time to
switch off the heat setting.
• Press the [BACKLIGHT] button to adjust the colours of the LED decoration, 7 colours
are available.
Remote Operation
The standby rocker switch located at the top right
hand side of the fireplace must first be switched on.
The fireplace will beep to indicate that it is powered
up. It takes a little time for the receiver to respond to
the transmitter. Do not press the buttons more than
once within two seconds for the fireplace to operate
normally.
1. Plug the power plug of the appliance into the
power outlet.
2. Turn on the power switch.
3. Press the control switch or the [ON/OFF] button
on the remote control to start up.
4. Press the [1000W/2000W] button once for the
low heat setting (1000 W). Press the button a
second time for the high heat setting (2000 W).
Press the button a third time to switch off the heat
setting.
5. Press the [COLOR] button to activate the colour
mode, 7 colours available.
6. Press the [BACKLIGHT] button to adjust the
colours of the LED decoration, 7 colours are
available.