3.5 Krantrans-
port mit dem
HT Umsetzbügel
•
Für den Umsetzvorgang
eines H 20 Deckenti-
sches werden immer 4
HT Umsetzbügel an den
Enden der beiden Joch-
träger angeschlossen.
•
Die Tragfähigkeit des
Kranes muss für das
maximale Gewicht der
Einheit ausgelegt sein.
•
Den HT Umsetzbügel
nur über ein Vierstrang-
Gehänge mit dem Haken
des Krans verbinden.
•
Das ausreichend tragfä-
hige Vierstrang-Gehänge
muss über Lasthaken mit
Sicherungsfalle verfü-
gen.
•
Der Spreizwinkel der
Kranseile darf 60° nicht
überschreiten.
HÜNNEBECK GmbH
Postfach 10 44 61, 40855 RATINGEN, GERMANY
Tel.: +49 (0) 2102 937-1, Fax: +49 (0) 2102 37651
info_de@huennebeck.com, www.huennebeck.de
Fig. 7
≤60°
Belagträger
Girder
Alle Maße in cm, wenn nicht anders angegeben.
Unless stated otherwise all dimensions are in cm.
HT Umsetzbügel
HT crane hook
3.5 Crane transport with
•
For shifting of an H 20
floor table always use 4
HT crane hook at each
end of both main beams.
•
The load-bearing
capacity of the crane
must match with the
maximum weight of a
unit.
•
Only connect the
HT crane hook to the
hook of the crane by
using a four-leg lifting
gear.
•
The four-leg lifting gear
Jochträger
with sufficiently load-
Main beam
bearing capacity must
provide hooks with
safety catches.
•
The spreading angle of
the lifting gear must not
exceed 60°.
the HT crane hook
9