Operation Tips; Maintenance; General Maintenance; Lubrication - GreenWorks LMF320 Bedienungshandbuch

EN
• Make sure that your footing is stable. If you are out of
balance, release the bail switch immediately.
• Do not mow near drop-offs, ditches, or embankments.
4.5

OPERATION TIPS

• Do not try to override the operation of the start button or
bail switch.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick grass.
• Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
5

MAINTENANCE

Remove the safety key and battery pack from the machine
before maintenance.
Keep the engine and battery pack free from grass, leaves or
too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
5.1

GENERAL MAINTENANCE

• Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use water.
5.2

LUBRICATION

Apply sufficient quantity of high grade lubricant to all
bearings. No more bearing lubrication is necessary in usual
operation conditions.
WARNING
WARNING
CAUTION
CAUTION
CAUTION
English
Do not lubricate the wheel components. Lubrication can
cause damage to the wheel components during operation.
5.3

REPLACE THE BLADE

Figure 10.
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blades fully stop.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting screw and spacers with a wrench
or socket.
7. Remove the blade.
8. Install the new blade. Make sure that the raised points
engage the holes in the blade.
9. Put in the mounting screw and spacers and tighten them.
5.4

REPLACE THE WHEELS

Figure 11.
You must clean the wheel assembly before you put it into
storage to make sure that the wheels operate correctly.
1. Remove the opening pins and the washers.
2. Remove the wheel.
3. Replace with new wheel.
4. Replace the washers, pins and the wheel covers.
5.5

REPLACE THE BATTERY PACK

If you use battery packs that are not recommended by the
manufacturer, there is a risk of fire, electric shock, or
personal injury.
The battery pack is designed for maximum life; however, like
all batteries, it will eventually need to be replaced. Charge the
new battery pack before use.
1. Remove the safety key.
2. Carefully unlock and remove the battery pack.
3. Install the new battery pack.
6
WARNING
WARNING
WARNING
WARNING