Dimplex LA 22TBS Montage- Und Gebrauchsanweisung Seite 25

7 Complies with the European safety regulations
8 Additional model features
8.1 Type of defrosting
8.2 Frost protection, condensate tray /
Water in device protected against freezing
8.3 Max. operating overpressure (heat sink)
1. For air temperatures of -22 °C to 0 °C, flow temperature increasing from 54 °C to 65 °C.
2. The heat output and COP is reduced by approx. 5 % in lower operation
3. The maximum sound power level under full load can increase by up to 5 dB(A)
4. The specified sound pressure level corresponds to the operating noise of the heat pump in heating operation at 35 °C flow temperature.
The specified sound pressure level represents the free sound area level. The measured value can deviate by up to 16 dB(A), depending on the installation location.
5. These data indicate the size and capacity of the system according to EN 14511 (5K at A7). For an analysis of the economic and energy efficiency of the system, other parameters,
in particular the defrosting capacity, the bivalence point and regulation, should also be taken into consideration. These figures are only achieved with clean heat exchangers. In-
formation on maintenance, commissioning and operation can be found in the respective sections of the installation and operating instructions.
The specified values have the following meaning, e.g. A7 / W35: 7 °C outside temperature and 35 °C heating water flow temperature.
6. See CE declaration of conformity
7. The heat circulating pump and the heat pump manager must always be ready for operation.
www.dimplex.de
7
bar
452166.66.01 · FD 9407
LA 22TBS - LA 28TBS
6
Reverse circulation
Yes
3,0
6
Reverse circulation
Yes
3,0
EN-11