Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1 Replacing the switch
EN - 10
Switch Replacement for CAT3 PRO
3 Tighten the set screw with the Allen key
(SW 2) (tightening torque 2.2 Nm) and
ensure that the switching point does not
change.
4 Tighten the cylinder head screws (M3 × 6)
on the retaining sheet with the Allen key
(SW 2.5) (tightening torque 1.3 Nm).
5 We recommend marking the position of
the switch with sealing wax.
6 Place the cable in the connector housing.
Ensure that the cables between the switch
housing and CAT3 PRO housing are not
pinched.
BEI.0369.0 • 2021-02-16
Werbung
