On the working conditions, the operator can decide
which side of the V-block is to be placed on the
press table. Place the V-blocks in the same
distance on the press table
Note: To prevent the arrest and slipping on the
press table, attach the supplied 4 Bolts (B1) in the
V-prism blocks (Fig. 7)
14.2.3 Manual operation
There are 2 handle sockets, one on top and one on
the bottom of the pump, the upper one is for high
pressure and low speed; and the lower one is for
low pressure and faster speed. One handle tube is
used for both pumps.
A): When operating the high pressure pump, insert
the handle tube (50) into the handle socket (31) as
shown in above fig.
B): When operating the low pressure pump, please
insert the handle tube (50) into the socket (43). Please
refer to the fig.
14.2.4 Air purge manually
Turn the handle lever of selector valve to position 2
(refer to fig. 8)
Fig .8
HOLZMANN Maschinen Austria
All manuals and user guides at all-guides.com
www.holzmann-maschinen.at
Fig. 7
1
When the handle lever (99) in position 1,
the piston rod is returning
2
When the lever (99) in position 2, the
piston rod is stopping moving
3
When the handle lever (99) in position 3,
the piston rod is extending
Werkstattpresse / shop press
OPERATION
Seite 46
WP 50H - WP 75H - WP 100