14.1.3
Press cylinder sideways
The 4 screws holding the plate pressing cylinder open and the press cylinder position it centrally
over the workpiece. Following screws tighten.
14.2 WP 100H
14.2.1 Press cylinder sideways
Insert the handle (12) to the worm connecting
shaft (M1)
Turning the handle clockwise, and the ram moves
left (Direction A).
Turning the handle (12) anti-clockwise, and the
ram moves right (Direction B)
14.2.2
Press the table height
Insert the handle (12) to the worm shaft (W12)
Turning the handle (12) clockwise, the working bed will
lift (direction A)
Turing the handle (12) anti-clockwise, the working bed
be lowered (direction B)
Make the press table (19) to the correct height, then insert the safety pin (21). In the holes in
the frame and lock with snap rings (22) (Figs. 5 and 6)
Fig. 5
HOLZMANN Maschinen Austria
All manuals and user guides at all-guides.com
www.holzmann-maschinen.at
Fig. 6
Werkstattpresse / shop press
OPERATION
Seite 45
WP 50H - WP 75H - WP 100