Troubleshooting - BATTIPAV Super Pro Serie Bedienungsanleitung

Battipav srl

TROUBLESHOOTING

THIS TOOL MUST ONLY BE REPAIRED BY TRAINED PERSONNEL.
Repairs must only be carried out by trained personnel, using original spare parts. Any other repairs may put
the user at considerable risk.
Malfunctions not related to a conformity defect that exists at the time of purchase are excluded from the
warranty. Exclusions include:
- Wear of materials (taking into account the average life of the product)
- Failure to comply with the recommendations contained in this manual.
- Maintenance and tampering carried out by unauthorized personnel.
- Use of non-original spare parts.
Problem
The cutting carriage is difficult to
slide.
The cutting carriage slides unevenly.
The cutting wheel does not cut
correctly.
Cause
The carriage rod is encrusted with
cutting residue.
The carriage rod is worn.
The bearings on the cutting carriage are
worn.
There is too much play on the tile cutter.
The bearings on the cutting carriage
have been damaged.
The clamp on the cutting foot support
is worn.
The cutting wheel is worn.
The screw on the cutting wheel support
has become loose.
15
Solution
Clean cutting residue off the rod and
check that the carriage is adjusted
correctly.
Contact your local dealer to replace the
carriage rod.
Contact your local dealer to replace the
bearings.
Check that the carriage is adjusted
correctly.
Contact your local dealer to replace the
bearings.
Contact your local dealer to replace the
cutting foot.
Replace the cutting wheel.
Check that the cutting wheel is adjusted
correctly.
GB