Dräger UCF 1600 Gebrauchsanweisung Seite 21

Transmitter handle
Fault
Image on receiver unit is snowy.
No image on the display.
The display of the receiver unit remains black,
although the receiver unit is switched on.
Image on receiver unit is not clear.
Transmitter does not change channels.
Screen is dim on receiver unit.
Range of system is low.
Transmitter does not turn on.
Downloaded from www.Manualslib.com
Cause
Transmitter/camera is off, on wrong channel,
or malfunctioning.
Transmitter or receiver unit is switched off.
Camera or transmitter does not function
correctly.
Excess interference
Wrong channel.
Transmitter is not working.
Low video signal or bad screen.
Transmitter or receiver unit on incorrect
channel.
Bad or no electrical connection between
thermal imaging camera and transmitter
handle.
manuals search engine
Remedy
Turn transmitter and camera on or change
channels. If the receiver unit has the same
symptons, contact Dräger Safety.
Make sure that transmitter and receiver unit
are switched on.
Make sure that both camera and transmitter
are operational. If the receiver unit shows the
same symptoms, contact Dräger Safety.
Make sure that both the camera with
transmitter and receiver unit are within close
proximity to one another (approximately two
feet) and are on the same channel.
Confirm that the receiver unit is not too close
to a wireless network, a microwave oven or
any other signals that might be sharing the
same frequency. If the receiver unit has the
same symptoms, contact Dräger Safety.
Change channel on transmitter or receiver
unit.
Contact Dräger Safety.
Contact Dräger Safety or your monitor/PC
supplier.
Change channel on transmitter or receiver.
Make sure that the transmitter handle is
correctly attached to the thermal imaging
camera. The thumb wheel must be screwed
tightly.
21