Dräger UCF 1600 Gebrauchsanweisung Seite 15

The "Gray Scale White Hot" and "Gray Scale Black Hot" color
palettes offer "source of the fire" colorization: Only the pixels of a
scene which are saturated (i.e. the source of the fire) will be displayed
in red indicating the hot spot of a scene. This feature can be used to
look for pockets of ember or other hot spots.
"TempColor" is the standard color palette setting. When the thermal
imaging camera is switched on and neither the firefighting mode nor
the ThermalScan feature is activated, you can toggle between the
different color palettes as follows:
Press the MODE button for more than 1.5 seconds.
The thermal image will be displayed in another color palette.
Each time you press the MODE button for more than 1.5 seconds,
the thermal imaging camera selects the next color palette.
When the thermal imaging camera switches to the firefighting mode,
the standard color palette "TempColor" is used regardless of the
selected color palette.
When the camera returns to normal mode again, the previously
selected color palette will be shown again.
ThermalScan feature (optional)
This feature is only available in normal mode. When the thermal
imaging camera switches to firefighter mode, the "TempColor" color
palette is used as a standard.
When the ThermalScan feature is activated, all the objects which are
hotter than the set threshold are displayed in yellow (see also
page 374). No other color palette can be selected.
The ThermalScan buttons are only active if the thermal imaging
camera is turned on and not in stand-by mode.
Downloaded from www.Manualslib.com manuals search engine
Activating the ThermalScan feature
Press either the DOWN or the UP button for approx. 1 second.
o o
"TS > 140 F" or "TS > 60 C" is indicated on the screen. This is the
default value.
Changing the ThermalScan threshold
To raise the ThermalScan threshold, press the UP button.
The respective threshold is indicated on the screen.
To lower the ThermalScan threshold, press the DOWN button.
The respective threshold is indicated on the screen.
If you hold down the DOWN or UP button, the threshold will change
more quickly.
Deactivating the ThermalScan feature
Simultaneously press both the UP and the DOWN buttons and
hold for approx. 1 second.
The ThermalScan threshold will disappear from the screen.
Transmitter handle (optional)
The transmitter is a two-channel analog FM, video transmitter.
NOTICE
Before using the thermal imaging camera with transmitter system,
check whether you have or need a license for the use of a high
frequency transmitter system with these frequencies.
Technical details like operating frequencies and power level can be
found in the documentation of the transmitter handle.
If you need more information, please contact Dräger Safety.
15